Bottle Cap Snacky
This great addition to your bottle cap allows you to enjoy a fun snack while enjoying your drink. We have designed the Bottlecap Snacky in three sizes. This was designed in TinkerCAD.
Print Instructions
This build is a quick print, but supports are needed. We find it’s best to print with the bottlecap facing up. This means more support material will be used, but the grooves in the bottlecap will print better.
Material: PLA
Infill: 10%
Support: Yes
Print Time: 45-60 Minutes
This build is a quick print, but supports are needed. We find it’s best to print with the bottlecap facing up. This means more support material will be used, but the grooves in the bottlecap will print better.
Material: PLA
Infill: 10%
Support: Yes
Print Time: 45-60 Minutes
STL Files
| Bottle Cap Snacky.stl |
Created by: Dave Piemme ([email protected])